3D Printer

This chapter will guide you through the basic process for using the printer. For simplicity, we'l...

Find the Dell laptop used for 3D printing, plug it in, and turn it on. It's a Dell laptop and wil...

Model Sources If you aren’t sure what you want to print, there are many websites where folks hav...

There are lots of different plastics that you can print. For the most part, unless you’re doing s...

Overview Power On Flip on the power switch on the back right of the printer. Inspect The ...

You only need to perform the following steps if you want to use a different filament than the kin...

Check that the filament spool you want to load is of the correct type. Unless you're doing some...

Setup "Slicing" is the process of turning a 3D model (typically an STL file) into a series of la...

Finally, you can send the job to the printer. In the upper right hand corner, click “Print Plate”...

Started a print but it's not working? Look here!

Often this is caused by contamination on the bed. Wash it well with soap and water, dry it with a...

If the filament isn't wound properly around the spool, it can tighten itself into almost a "knot"...

Check the removable bed surface to make sure it's properly positioned. It should be flat on all...

Sometimes filament can break while it's being fed from the spool into the extruder. This is parti...