Recently Updated Pages

The Capitol Hill Farmers Market runs every Sunday from 11:00 AM to 3:00 PM, at the intersection o...

Often this is caused by contamination on the bed. Wash it well with soap and water, dry it with a...

This is a guide for shift leads and existing volunteers, describing how to welcome and onboard vo...

Resetting The Breaker Unfortunately, all our tools are on the same circuit breaker, so if many a...

As a theft prevention measure, the front door keypad is screwed into the info box from the inside...

When the keypad blinks red after entering a code successfully, the batteries are running low.  S...

Thank you so much for volunteering at the tool library! Before arriving If you get a chance, cr...

The specific edition of Fusion 360 that you want is called "Fusion 360 for Personal Use." Click ...

Sometimes filament can break while it's being fed from the spool into the extruder. This is parti...

Check the removable bed surface to make sure it's properly positioned. It should be flat on all...

If the filament isn't wound properly around the spool, it can tighten itself into almost a "knot"...

Overview Power On Flip on the power switch on the back right of the printer.  Inspect The ...

Check that the filament spool you want to load is of the correct type. Unless you're doing some...

Setup "Slicing" is the process of turning a 3D model (typically an STL file) into a series of la...

There are lots of different plastics that you can print. For the most part, unless you’re doing s...

Model Sources If you aren’t sure what you want to print, there are many websites where folks hav...

Finally, you can send the job to the printer. In the upper right hand corner, click “Print Plate”...

You only need to perform the following steps if you want to use a different filament than the kin...

Find the Dell laptop used for 3D printing, plug it in, and turn it on. It's a Dell laptop and wil...